Description

Seat Leon Cupra 290 2015-2017 Resonator Delete Pipe

 

To Fit:- Seat Leon Cupra 290 2wd Hatch

Year:- 2015 to 2017

• Does not fit Cupra 290ST models.
• Does not fit 4wd models.
• Fits models with 70mm front pipe only.

 

Description

This is a centre silencer delete / mid silencer delete / resonator delete / deres pipe designed to fit the Seat Leon Cupra 290 standard factory oe exhaust system.

• Please note, Seat changed the exhaust on the Cupra 290 in early 2018.
• This part only fits models from 2015 to 2017

If you are unsure which one you need for your car, please contact us.

This part is designed to give a slightly sportier sound so there is no need to buy an expensive aftermarket exhaust system.

You will also gain a small performance advantage by removing the restrictive, standard exhaust silencer.

Designed to easily remove the centre silencer on your Seat Leon Cupra 290’s standard exhaust system.

• Fits the standard factory oe exhaust only. It WILL NOT fit any aftermarket or performance exhaust.
• Please check your exhaust carefully for compatibility before purchasing.
• Only fits the vehicle listed. It will NOT fit any other vehicles.

Please contact us on our facebook page if you have any questions about this part. www.facebook.com/ZaustworxCustomExhausts/

 

• Fully reversible.
• Clamp on fitment, so no welding required.
• Supplied with clamps required for fitting.
• Premium quality 304 grade stainless steel.
• Lifetime guarantee.
• Fitting is available if required.
• Contact us on 01282 414902 if you require a fitting price.

 

There is a video of this exhaust on our youtube channel.

Click on the link below

 

Hand made to order, therefore please allow up to 24 hours for dispatch (excluding weekends).

 

Fitting instructions:-

• Simply cut the standard exhaust where shown in the photos and as described below, then clamp this new part into position.
• Cut 3″ after the pipe joint as shown in the photos and then sleeve this pipe over the original exhaust.
• Undo the joining sleeve at the front end and clamp this new pipe into position by using the original joining sleeve.
• See photos for cutting position.
• We recommend using a power saw for easy access and accuracy.
• You will need to use exhaust assembly paste when fitting this part (not supplied).
• Designed for easy DIY fitment, however if you have any doubts about fitting yourself then we would recommend professional fitting.

 

This is a genuine Zaustworx part.

Designed, developed and manufactured by ourselves on our own premises in the UK.

We only use high quality UK sourced 304 grade stainless steel.

We have 25+ years experience in the exhaust industry.